Secuself CCTV camera FVC033 FVC033 Data Sheet

7 

Connecting to a Wireless Network using WPS 

Connecting the IP camera to a wireless network using WPS (Wi-Fi Protected 
Setup) requires that the router and Operating System supports WPS 
functionality. 
NOTE – Some routers have a virtual button on their management software. 
(Refer to the router’s documentation for details about using its WPS functions). 
1.   Once the power cord is connected, wait for 5 minutes for the camera to boot 

up. 

2.   Press and hold down the WPS button on the IP camera and the WPS button 

on the router respectively for 2 seconds. The GREEN network indicator light 
indicates that your IP camera is now ready for defining camera settings 
(Refer to Defining IP Camera Settings). 

Connecting to a Wireless Network using the RISCO Cloud 

Connecting the IP camera to a wireless network using the RISCO Cloud (RISCO 
Application Server) requires that you first physically connect the IP camera to the 
router and then, from the RISCO Cloud Installer Application, define the IP 
camera settings and establish a wireless connection. Once a wireless connection 
has been established the IP camera can then be disconnected from the router and 
installed. 
1.   Connect the incoming network cable to the Network port on the IP camera. 
2.   Wait just a few minutes while the IP camera automatically connects to the 

RISCO Cloud (RISCO Application Server). The RED network indicator light 
indicates that your IP camera is now ready

 

for defining camera settings 

(Refer to Defining IP Camera Settings). 

3.   Once a wireless connection has been established, disconnect the IP camera 

from the router and install it anywhere within the monitored area.