Tripp Lite 3.2-3.8kW Single-Phase ATS/Switched PDU, 200-240V Outlets (8 C13 & 2 C19), 2 C20, 12ft Cord, 1U Rack-Mount PDUMH20HVATNET Data Sheet

MODEL NUMBER: PDUMH20HVATNET

 

 

 

Tripp Lite Switched ATS / Auto Transfer Switch provides a redundant power option for single-corded network

devices. Dual input cords support separate connection to PRIMARY and SECONDARY power sources. The

ATS will normally maintain continuous output to all outlets as derived from the primary input cable. If the primary

power source becomes unstable or fails altogether, the ATS will switch over to the secondary power source until

the primary input is restored and stable. Switched PDU features include individually controllable output

receptacles and built-in network interface. Super-fast switchover between primary and secondary power sources

occurs within milliseconds. ATS functionality is supported by any two compatible AC power sources, regardless

of phase angle, to support a variety of advanced redundant power networking applications. Enables fault tolerant

hot-swappable UPS protection when used with a single UPS and fully redundant UPS protection when each cord

is connected to a separate UPS system. In a two-UPS environment, the primary input cable must be supported

by a full time sine wave UPS with zero transfer time. Tripp Lite SmartOnline series is highly recommended for

use as the primary UPS in a two-UPS application. ATS configurations utilizing separate mains circuits, backup

generators and even separate utility power grid feeds are fully supported. On-board ATS processor constantly

evaluates power quality on both input sources to prevent transfer to the secondary source when unavailable or of

lower quality than the primary source. Front input LED's display primary or secondary power availability. 

200-240V 16/20A Automatic Transfer Switch (ATS) / Switched PDU (Agency de-rated to 16A continuous)

Enables redundant A/B power option for single-corded network devices

2 digit display reports power consumption in amps

1U horizontal rackmount form factor

10 outlets (8 C13 switched / 2 C19 unswitched)

 Two C20 inlets for separate Primary and Secondary inputs; two 12 ft / 3.7m C20 input cables included

ATS circuits normally maintain output sourced from the primary input cable; As primary input power fails, the ATS will switch to maintain output sourced

Single phase 16/20A 200-240V

Auto Transfer Switch / ATS PDU

Enables redundant A/B power

option for single-corded network

devices

Separate primary & secondary

inputs connect to any two

compatible power sources

1U horizontal rackmount; 10

outlets (8 C13 switched / 2 C19

unswitched)

Individually switched outlets,

network interface and 2 digit

visual current meter

Ideal for configurations requiring

a simple PDU that displays

power consumption in amps

Optional-use ATS function

makes this system ideal for

adding redundancy to single

corded devices

ATS function adds hot-swap and

maintenance bypass function to

standard UPS configurations

Switch, Metered PDU with ATS

Support

Set of 2 C19 to C20 12 ft. / 3.7m

power cables

User manual with warranty

information

1 / 4