Tripp Lite 5kW Single-Phase ATS/Switched PDU, 208V (16 C13, 2 C19 & 1 L6-30R) 2 L6-30P Input Cords, 2U Rack-Mount PDUMH30HVATNET Data Sheet

MODEL NUMBER: PDUMH30HVATNET

 

 

 

Tripp Lite Switched ATS / Auto Transfer Switch provides a redundant power option for single-corded network

devices. Dual input cords support separate connection to PRIMARY and SECONDARY power sources. The

ATS will normally maintain continuous output to all outlets as derived from the primary input cable. If the primary

power source becomes unstable or fails altogether, the ATS will switch over to the secondary power source until

the primary input is restored and stable. Highly reliable solid-state switching between primary and secondary

inputs occurs in 1-5 milliseconds. Switched PDU features include individually controllable output receptacles and

built-in network interface. Super-fast switchover between primary and secondary power sources occurs within

milliseconds. ATS functionality is supported by any two compatible AC power sources, regardless of phase

angle, to support a variety of advanced redundant power networking applications. Enables fault tolerant

hot-swappable UPS protection when used with a single UPS and fully redundant UPS protection when each cord is connected to a separate UPS system. In a

two-UPS environment, the primary input cable must be supported by a full time sine wave UPS with zero transfer time. Tripp Lite SmartOnline series is highly

recommended for use as the primary UPS in a two-UPS application. ATS configurations utilizing separate mains circuits, backup generators and even

separate utility power grid feeds are fully supported. On-board ATS processor constantly evaluates power quality on both input sources to prevent transfer to

the secondary source when unavailable or of lower quality than the primary source. Front input LED's display primary or secondary power availability. 

208V 30A Automatic Transfer Switch (ATS) / Switched PDU (Agency de-rated to 24A continuous)

ATS features provide redundant power for critical network equipment with a single input power cord

2 digit display reports output power consumption in amps

2U horizontal rackmount form factor; 12.5 in. / 31.8 cm depth

19 built-in switched outlets (16 C13, 2 C19 & 1 L6-30R) 

Set of two 10 ft. / 3m NEMA L6-30P input cables support connection to separate PRIMARY and SECONDARY inputs

ATS circuits normally maintain output sourced from the primary input cable; As primary input power fails or becomes unstable, the ATS will switch to

maintain output sourced from the secondary input cable until power on the primary input is restored and stable

Single phase 30A 208V Auto

Transfer Switch / ATS PDU with

Solid State Switching

Enables redundant-power option

for single-corded network devices

Separate primary & secondary

inputs connect to any two

compatible power sources

2U rackmount, 2 L6-30P inputs,

19 switched outlets (16 C13, 2

C19, 1 L6-30R)

Individually switched outlets,

network interface and visual

current, voltage and

environmental monitoring

ATS PDU systems provide a

redundant power option with

individual outlet control for

single-corded network devices

2U ATS PDU

Rackmount installation brackets 

Cable retention plates and cable

ties

User manual

1 / 4