Intel i3-2328M FF8062701275100 Data Sheet

Product codes
FF8062701275100
Page of 170
Datasheet, Volume 1
77
Signal Description
6.2
Memory Reference and Compensation Signals
Table 6-3.
Memory Channel B Signals 
Signal Name
Description 
Direction/
Buffer Type
SB_BS[2:0]
Bank Select: These signals define which banks are selected within 
each SDRAM rank.
O
DDR3
SB_WE#
Write Enable Control Signal: This signal is used with SB_RAS# and 
SB_CAS# (along with SB_CS#) to define the SDRAM Commands.
O
DDR3
SB_RAS#
RAS Control Signal: This signal is used with SB_CAS# and SB_WE# 
(along with SB_CS#) to define the SRAM Commands.
O
DDR3
SB_CAS#
CAS Control Signal: This signal is used with SB_RAS# and SB_WE# 
(along with SB_CS#) to define the SRAM Commands.
O
DDR3
SB_DQS[7:0] 
SB_DQS#[7:0]
Data Strobes: SB_DQS[7:0] and its complement signal group make 
up a differential strobe pair. The data is captured at the crossing point 
of SB_DQS[8:0] and its SB_DQS#[7:0] during read and write 
transactions.
I/O
DDR3 
SB_DQ[63:0]
Data Bus: Channel B data signal interface to the SDRAM data bus.
I/O
DDR3 
SB_MA[15:0]
Memory Address: These signals are used to provide the multiplexed 
row and column address to the SDRAM.
O
DDR3
SB_CK[1:0]
SDRAM Differential Clock: Channel B SDRAM Differential clock signal 
pair. The crossing of the positive edge of SB_CK and the negative edge 
of its complement SB_CK# are used to sample the command and 
control signals on the SDRAM.
O
DDR3
SB_CK#[1:0]
SDRAM Inverted Differential Clock: Channel B SDRAM Differential 
clock signal-pair complement.
O
DDR3
SB_CKE[1:0]
Clock Enable: (1 per rank). These signals are used to:
• Initialize the SDRAMs during power-up.
• Power-down SDRAM ranks.
• Place all SDRAM ranks into and out of self-refresh during STR.
O
DDR3
SB_CS#[1:0]
Chip Select: (1 per rank). These signals are used to select particular 
SDRAM components during the active state. There is one Chip Select 
for each SDRAM rank.
O
DDR3
SB_ODT[1:0]
On Die Termination: Active Termination Control.
O
DDR3
Table 6-4.
Memory Reference and Compensation 
Signal Name
Description 
Direction/
Buffer Type
SM_RCOMP[2:0]
System Memory Impedance Compensation:
I
A
SM_VREF
DDR3 Reference Voltage: This provides reference voltage to the 
DDR3 interface and is defined as V
DDQ
/2.
I
A