Intel 9560 CM8063101049716 Data Sheet

38

1.

This is the swing specification for the forwarded CLK output. Note that this specification will also have to be suitably de-

embedded for package/PCB loss to translate the value to the pad, since there is a significant variation between traces in a 

setup.

2.

While the X-talk is off, on-die noise similar to that occurring with all the transmitter and receiver lanes toggling will still need 

to be present. When a socket is not present in the transmitter measurement setup, in many cases the contribution of the 

cross-talk is not significant or can be estimated within tolerable error even with all the transmitter lanes sending patterns. 

Therefore for all Tx measurements, use of a socket should be avoided. The contribution of cross-talk may be significant and 

should be done using the same setup at Tx and compared against the expectations of full link signaling. Note that there may 

be cases when one of Dj and Rj specs is met and another violated in which case the signaling analysis should be ran to 

determine link feasibility.

3.

DC CM can be relaxed to 0.20 and 0.30 Vdiffp-p swing if RX has wide DC common mode range.

 specifies absolute maximum and minimum ratings for the Intel

®

 Itanium

®

 

Processor 9300 Series. Within operational maximum and minimum limits, the 
processor functionality and long-term reliability can be expected. The processor 
maximum ratings listed in 

 are applicable for the 130 W, 155 W, and 185 W 

parts.

 specifies absolute maximum and minimum ratings for the Intel

®

 Itanium

®

 

Processor 9500 Series. Within operational maximum and minimum limits, the 
processor functionality and long-term reliability can be expected. The processor 
maximum ratings listed in 

 are applicable for the 130 W and 170 W parts.

At conditions outside operational maximum ratings, but within absolute maximum and 
minimum ratings, neither functionality nor long-term reliability can be expected. If a 
device is returned to conditions within operational maximum and minimum ratings 
after having been subjected to conditions outside these limits, but within the absolute 
maximum and minimum ratings, the device may be functional, but with its lifetime 
degraded depending on exposure to conditions exceeding the functional operation 
condition limits.

VRx-Vmargin

Any data lane Rx input voltage 

(differential pp) measured at BER=1E-9

100

mV

TRx-Tmargin 

Timing width for any data lane using 

repetitive patterns and clean forwarded 

CLK, measured at BER=1E-9

0.8

UI

V

Rx-cm-dc-pin

DC common mode ranges at the Rx input 

for any data or clock channel, defined as 

average of VD+ and VD-.

125

350

mV

V

Rx-cm-ac-pin

AC common mode ranges at the Rx input 

for any data or clock channel, defined as:
((V

D+

 + V

D-

/2 - V

RX-cm-dc-pin

)

-50

50

mV

F

PLL-BW_TX-RX

-3dB bandwidth

4

16

MHz

JitPk

TX-RX

Jitter Peaking

3

dB