Saeco Super-automatic espresso machine HD8750/18 HD8750/18 Data Sheet

Product codes
HD8750/18
Page of 48
39
ENGLISH
TROUBLESHOOTING
This chapter summarizes the most common problems you could encounter 
with your machine. If you are unable to solve the problem with the 
information below, visit www.philips.com/support for a list of frequently 
asked questions or contact the Philips Saeco hotline in your country. The 
contact details can be found in the warranty booklet packed separately or 
on www.philips.com/support.
Machine actions 
Causes 
Solutions
The machine does not turn 
on.
The machine is not connected to 
the electric network.
Connect the machine to the electric 
network. 
Coff ee is not hot enough.
The cups are cold.
Preheat the cups with hot water.
The drip tray gets fi lled 
although no water is drained.
Sometimes water is drained 
automatically by the machine 
into the drip tray to manage the 
rinsing of the circuits and ensure 
optimum machine performance.
This is a standard operating 
procedure.
The fast blinking red 
 light 
is always displayed on the 
machine.
The coff ee grounds drawer was 
emptied with the machine off .
The coff ee grounds drawer must 
always be emptied with the machine 
on. Wait until the red 
 light 
starts blinking more slowly before 
reinserting the drawer.
No hot water or steam is 
dispensed.
The hole of the steam wand is 
clogged.
Clean the hole of the steam wand 
using a pin.
 Caution: Make sure that the 
machine is off  and has cooled 
down before performing this 
operation.
The Classic Milk Frother is dirty.
Clean the Classic Milk Frother.
Coff ee does not have 
enough crema.
(See note)
The blend is unsuitable, coff ee is 
not freshly roasted or the grind is 
too coarse.
Change coff ee blend or adjust the 
grind as explained in the "Adjusting 
the Coff ee Grinder" section.
The machine takes a long 
time to warm up or the 
amount of water dispensed 
from the wand is too little.
The machine circuit is clogged by 
limescale. 
Descale the machine. 
The brew group cannot be 
removed.
The brew group is out of place.
Turn on the machine. Close the 
service door. The brew group 
automatically returns to the initial 
position.
The coff ee grounds drawer is 
inserted.
Remove the coff ee grounds drawer 
before removing the brew group.
There is a lot of ground coff ee 
under the brew group. 
Coff ee is not suitable for automatic 
machines.
It may be necessary to change the 
type of coff ee or the coff ee grinder 
settings.