Vortech Engineering Supercharger System 4NT020-010 User Manual

Locate the CAC radiator between the two
angled cross members, lining up the two
bottom bracket mounting locations. Bend
the horn bracket as necessary to provide
clearance. (See Fig. 7-d.)

Use a supplied sheet metal screw to
secure the upper bracket to the core sup-
port.

Connect a 48" piece of hose to the pas-
senger’s side fitting on the CAC radiator.
Route the hose around the passenger’s
side of the radiator and up to the straight
fitting installed in the charge cooler.

Attach the water pump to the water reser-
voir using the supplied adel clamp in the
position shown. (See Fig. 7-e.)

Cut off the electrical plug on the water
pump leaving as much wire connected to
the pump as possible. Install the supplied
1/4" eyelet on the water pump ground
wire (brown wire). Install a male slide con-
nector onto the water pump positive wire
(green wire).

Using thread sealant, install a 1/2"NPT x
90° hose barb fitting into the top and bot-
tom of the supplied plastic reservoir.

Connect the pump inlet to the bottom
reservoir fitting with the supplied 90°
hose.

Insert the water reservoir into the sup-
plied bracket and insert into the area
behind the driver’s side front wheel next
to the frame rail.

Remove the two factory support screws
and re-install to secure the reservoir
bracket.

Use the supplied adel clamp and hard-
ware to secure the water pump to the
trailing edge of the vehicle’s bumper.
(See Fig. 7-f.)

From the engine compartment, route the
supplied 3/4" hose from the bottom of the
surge tank to the top of the reservoir.
(See Fig. 7-h.)

Connect a hose running from the water
pump discharge to the 90° fitting installed
on the driver’s side of the CAC radiator.

FACTORY SCREWS