Vortech Engineering Supercharger System 4NT020-010 User Manual

Disconnect the Battery.

Remove the engine cover.

Remove the engine cover bracket located
above the throttle body. Remove the wiring
harness bracket from above the driver’s side
valve cover.

Disconnect the two breather tubes running
from the intake manifold to the plastic intake
duct and remove the duct, air-box lid, filter
and air-box.

Remove the grill.

Locate and remove the two clamps securing
the A/C line to the driver’s side firewall. Install
the supplied adel clamp on the firewall. Flip
over to lower the A/C line. (Doing this lowers
the A/C line to clear supercharger componen-
try.)  (See Fig. 1-b.)

Remove the factory serpentine belt

Drain the engine coolant from the vehicle.

Remove the lower radiator hose connecting
the bottom of the radiator to the hard radiator
tube mounted off the engine’s front cover.

Remove the radiator hose that connects the
top opening of the hard radiator tube to the
plastic thermostat housing on the engine.
Remove the hard radiator tube.

Remove the MAF sensor from the factory air
box lid and set aside for reinstallation in an
upcoming step.

Remove the factory idler from the driver’s
side of the engine.

REMOVE THE

CLAMPS