Vortech Engineering Supercharger System 4NT020-010 User Manual

Locate the driver’s side cam cover. Remove
the eight 6mm screws and carefully pry the
cover from the cylinder head. (See Fig. 3-a.)

Clean any excess sealant from the mating
surface on the cam sprocket housing.

Install the supplied 3/8"NPT x 1/2" barb x 90°
fitting into the 3/8"NPT hole in the supplied
supercharger mounting plate.

Lay a thin bead of RTV silicone sealant along
the machined groove on the rear of the
mounting plate. Install the mounting plate
using the factory hardware within five min-
utes.

Tighten the screws to 10 ft/lbs.

Assemble the supplied M12 x 80mm screw,
washer, non-flanged idler, and spacer. Using
thread sealant, secure the assembly into the
12mm hole in the plate. (See Fig. 3-b.)

Connect the oil drain hose to the supercharg-
er and secure it with a #8 hose clamp.

Install the 90° x 1/8"NPT x –4 fitting into the
brass oil feed fitting in the supercharger. Use
oil on the threads, not teflon tape.

Guide the oil drain hose through the hole in
the mounting plate. Using the supplied 3/8-16
x 1" hardware and washers, secure the
supercharger to the mounting plate.

Install the idler into the center ear on the
supercharger gear case using the supplied
M12 x 50mm bolt, washer, dust cover and
spacer. (See Fig. 3-d.)

Connect the oil drain hose to the brass fitting
in the mounting plate and secure with the
supplied #8 hose clamp.

Route and install the belt. (See Fig. 3-e.)

TRIMMED SIDE OF 4PCW016-171 PULLEY