Source Technologies Secure MICR Printer ST9510 User Manual

ST Secure MICR Printer User’s Guide 

            

24

 

 

             2006, Source Technologies 

March 2006 

             All Rights Reserved

 

 

 

 

Error Messages 
 
A  majority of the printer error conditions are documented in the User’s manual for the 
printer.  The following are additional error conditions related to the ST Secure MICR printer. 
 
Toner Low 
The printer will stop with Error and Press Button lights on at the first indication of toner being 
low.  Press the button and the printer will return to Ready and continue printing.  The Toner 
Low light will be on steady.  While in the toner low state, the printer will stop again on power 
cycles and other situations such as jams or paper out conditions.  Simply press the button to 
continue printing.  The low toner condition will continue until the cartridge is replaced or 
Toner Out is reached. 
 
Toner Out 
After approximately 500 pages beyond the first Toner Low condition the printer will stop 
printing and display a Toner Out condition.  Both the Toner Low light and the Error light will 
blink.  All other lights will be off.  You must replace the cartridge to continue printing. 

 

 
The 250 pages are based on a printing coverage percentage of 5% per page average.  If 
actual printing uses less toner, the stop will occur after 250 pages. If the actual printing uses 
more toner the stop will occur short of 250 pages.  Actual toner usage determines TONER 
OUT. 
 
Load MICR Toner 
The ST Secure only supports MICR toner cartridges in its normal configuration.  This 
prevents the printing of MICR documents with standard toner.  If configured to support both 
MICR and standard cartridges, the PJL MICRJOB command checks the cartridge type and 
will prompt the operator with the following pattern to load MICR toner if not present.  

   

Blinking