Murphy PVS-5 Leaflet
00-02-0645
01-21-09
Section 78
In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time.
MURPHY, the Murphy logo, MurphyLink
MURPHY, the Murphy logo, MurphyLink
™
and PowerView
™
are registered and/or common law trademarks of Murphy Industries, Inc. This document,
including textual matter and illustrations, is copyright protected by Murphy Industries, Inc., with all rights reserved. (c) 2008 Murphy Industries, Inc.
PVS-5 Power Supply – Installation Instructions
• Provides 5 Volt power supply to PVM gages
• Capable of supplying power to a maximum of 6 PVM gages
• Enables PVM gage compatibility with existing MurphyLink products
• Easy mounting and installation
External power is required to make the PVM gage line compatible with existing
MurphyLink products, i.e. PV1000, Cascade, iGUARD and eGUARD. The PVS-5
power supply device supplies 5 Volts of external power and load dump
protection for up to 6 PVM gages. The maximum length of the power and data
connection between gages is 0.5meters (8.5 meters total).
The unit may be installed inside a panel or behind a dash.
Product Dimensions
Specifications
Input Voltage:
• 6 VDC minimum to 32 VDC maximum
• 12/24 VDC Nominal
Output Voltage: 5 VDC @ 450mA maximum
Output Voltage: 5 VDC @ 450mA maximum
Reverse Polarity Protection: -36VDC
Overvoltage Protection: +36VDC and above
Overcurrent Protection: 600mA @ 36VDA
maximum
maximum
Connector: AMP 1-770968-1
Operating Temperature: -40
°F to 185°F (-40°C to +85°C)
Storage Temperature: -40
°F to 221°F (40°C to +105°C)
Random Vibration: 5-2,000 Hz
Operating Shock: 50G
Certification: CE
Case Material: Polyamide
Dimensions: 2”x2”x.75”
Mounting Hole Dimensions: Two #8 screws,
1.625" offset
1.625" offset