Cardo SCALA RIDER G4 User Manual

gli

a. Turn on the designated Rider “B” unit and the Rider “C” unit by

pressing their Mobile Buttons until their blue light flash three times.

b. On both headsets press the Channel ”B” Buttons until the lights

are flashing rapidly in Blue indicating that Rider “B” and Rider

“C” are in Pairing mode.

c. Within a few seconds, both headsets will show a solid light for

two seconds, indicating that the two headsets are now paired,

connected and ready for use.

d. Turn on Unit “A” and wait until it reconnects to the factory

paired unit “B”. In case “A” and “B” don’t reconnect automatically,

press the “A” Button on unit “A” and connect manually.

NOTE: If the Pairing process is not completed within two minutes the

headsets will return to Standby mode.

Initiate Intercom calls

There are two ways to start an Intercom call with your paired headsets

while the headset is in Standby mode:

VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an

Intercom call will be established

with both paired headsets,

CHANNEL “A” and CHANNEL “B” (if

both are available).

CHANNEL BUTTON CONNECT:
Single tap the CHANNEL “A” But-

ton to add or remove the CHANNEL

“A” headset from an Intercom call.

Single tap the CHANNEL “B” But-

ton to add or remove the CHANNEL

“B” headset from an intercom call.

9.10c. FOUR-WAY INTERCOM

When connected to three other scala rider G4 units, your headset

can also participate in a 4-way Conference Intercom Call (full duplex)

as explained below.
Please note that the 4-way conference operates in a linear way,

whereby the two passengers serve as the connecting links for the

entire group. Therefore, if one of the Passengers disconnects, the 4-way

conference mode will be interrupted until that passenger is reconnected.

4-Way Intercom between up to two couples on two motorcycles

two drivers (1 and 3) and two passengers (2 and 4)

In this configuration the two passengers (numbered 2 and 4) are each

using two Bluetooth connections:
Passenger 2 is paired to Driver 1 and to Passenger 4
Passenger 4 is paired to Driver 3 and to Passenger 2

IMPORTANT: Since both Passengers each use two Bluetooth connections

during the conference mode, they will both be disconnected from

their mobile phones until the conference mode is terminated.

Upon termination, both Passengers will automatically re-connect

to their mobile phones. Both Drivers 1 and 3 remain connected to

their mobile phones or GPS devices during the 4-way intercom call

PAIRING FOUR SCALA RIDER G4 HEADSETS

INTERCOM

CHANNEL

PAIRING / CONNECTION

BUTTON

PAIRING MODE LED

INDICATORS

CHANNEL “A”

CHANNEL “A” BUTTON

Rapid RED flashing

CHANNEL “B”

CHANNEL “B” BUTTON

Rapid BLUE flashing

To converse in the 4-Way intercom conference mode, the four

headsets must be paired as shown in the biker illustration above. All

four units should initially be turned off.

scala rider

™

PowerSet