Cardo SCALA RIDER G4 User Manual

NOTE: The scala rider G4 PowerSet package, contains two factory

paired G4 headsets. If you did not change the original pairing

settings, you can skip “step one” below:

Step One: Pair Driver 1 to Passenger 2 via Channel “A” as follows

a. Turn both headsets ON by pressing and holding the Mobile

Buttons until the Blue Light flashes three times.

b. Both headsets should now be flashing slowly in Blue.
c. Press and hold CHANNEL (“A”) BUTTON on both headsets for at

least six seconds until the headset’s BLUE or RED Light begins

flashing rapidly, indicating that they have entered the Intercom

Pairing mode. (See Intercom Channel Table for Pairing Light

indication for each CHANNEL)

d. Release the buttons and wait until both headsets display a

solid light for two seconds, indicating that the two headsets are

now paired for Intercom connections. (This may take up to two

minutes)

Step Two: Pair Driver 3 to Passenger 4 via Channel “A”
Repeat the above pairing procedure between Driver 3 and Passenger 4
Step Three: Pair Passenger 2 to Passenger 4 via Channel “B”
Repeat the above pairing procedure between Passenger 2 and Pas-

senger 4 using the Channel “B” button. (instead of Channel “A” button

as described in bullet c above).

Your 4-Way Conference Intercom Pairing is now complete and ready

to use.

NOTE: If the Pairing process is not completed within two minutes the

headsets will return to Standby mode.

Making 4-Way Intercom calls
Once you have successfully paired the four headsets as described

above, and all units are in standby mode, proceed as follows to start a

4-way Conference Intercom call:

a. Passenger 2 should press Button “B” to initiate a call with

Passenger 4. Wait until audio is heard on both headsets and

proceed to the next step.

b. Driver 1 should press Button “A” to initiate a call with

Passenger 2.

c. Driver 3 should press Button “A” to initiate a call with

Passenger 4.

Now the 4-way intercom conference mode is established.

NOTE: If one of the headsets should disconnect or drop off from the 4-way

call and fails to reconnect, repeat the three steps above.

9.11 USING THE G4 FOR INTERCOM WITH OTHER

SCALA RIDER HEADSETS

INTERCOM

CHANNEL

PAIRING / CONNECTION

BUTTON

PAIRING MODE LED

INDICATORS

CHANNEL “A”

CHANNEL “A” BUTTON

Rapid RED flashing

CHANNEL “B”

CHANNEL “B” BUTTON

Rapid BLUE flashing

scala rider

™

PowerSet