Bravetti MC665H User Manual

Using the Pasta Function

When using the pasta function do not

go beyond the max line, in the cooking 

pot as the water will boil over and leak 

out of the pot. The maximum level of 

water is 1.6 qt (1.8L).

1. Place cooking pot into the unit. 

2. Fill the cooking pot with the 

required amount of water and 1 tsp 

oil, salt if desired.

3. Press down on the cover until it 

clicks into place.

4. Plug the detachable cord into the 

rear of the unit then plug the cord 

into a grounded-type 120V AC 

electrical wall outlet.

5. Press the function button three (3) 

times until the arrow on the LCD 

display is pointing to the pasta 

function. (Fig. 10) The numbers on 

the LCD display will not flash.

Using the Soup Function for 

5. If more than one hour is required, 

press the adjust button to change 

the number of hours up to a 

maximum of 4 hours.

6. Press the timer button to get the 

“:00” to flash. This means the 

minutes can be set for the 

steaming time required.

7. Press the adjust button to increase 

the minutes required for soups or 

stews. The minutes can be 

adjusted up to :59 minutes. 

Choose the cooking time required 

based on type of dish being 

prepared and amount.

8. Press the start button to begin the 

cooking process. The “:” (colon) on 

the LCD display will flash 

indicating that the timer is counting 

down.

9. When the function is complete the 

unit will beep. One minute later if 

the stop button has not been 

pressed the unit will switch to the 

keep warm function for six (6) 

hours.

10. Empty the water collector after 

each use.  Allow the unit to cool 

completely before cleaning.

Soups or Stews 
Note:

If using meat, see recipe 

section for directions on browning.

1. Plug unit into the wall outlet.

2. Fill the cooking pot with ingredients 

for stew or soup.  

3. Press down on the cover until it 

clicks into place.

4. Press the function button two (2) 

times until the arrow on the LCD 

display is pointing to the soup 

function. (Fig. 9) The numbers “01” 

will flash on the LCD display. The 

default time for the soup function is 

1 hour.

6. Press the start button.

7. The unit will begin to boil the water.

8. Once the water has come to a boil 

the unit will beep.

9. Prepare the pasta by placing in the 

pasta/steamer insert. Break in half if 

too long for the insert.

10. To insert the handle onto the pasta/ 

steamer insert, squeeze the ends of 

the handle and slide into guides on 

pasta/steamer insert and release the 

handle ends. 

11. Open the cover and carefully place 

the pasta/steamer insert into the 

cooking pot.

The water and steam are hot 

add the insert with extreme caution to 

avoid burns or injury.

12. Remove the handle from the pasta/ 

steamer insert.

13. Close the cover and press the adjust 

button to adjust the minutes required 

for cooking the type of pasta. The 

maximum time that can be set on the 

pasta function is 18 minutes.

14. Press the start button.

15. When the unit beeps again the pasta 

is ready. Press the stop button and 

unplug the unit. 

10.  If rice or other grains are found on 

the heating plate inside the main 

unit, they must be removed to 

avoid inadequate cooking. Use a 

damp sponge to wipe the surface 

of the heating plate clean. Do not

use any detergent on the heating 

plate.

: Do not use metal utensils or 

sharp metal objects such as a knife to 

remove food particles, this will 

damage the non-stick surfaces of the 

unit.

•

For best results when cooking 

rice, leave the rice settle in the 

unit for a few minutes before 

opening cover.

•

Stir rice thoroughly before 

serving.

•

To obtain a softer rice, allow the 

rice to soak in the cooking pot for 

10-15 minutes before cooking.

•

keep rice warm for more 

than 10 hours.

•

use metal utensils to stir 

rice, wooden utensils work best 

for perfect tasting rice.

The multi cooker should be cleaned 

thoroughly after every use:

1. Unplug unit from the wall outlet 

and allow to cool completely.

2. Remove the detachable cord from 

the main unit. 

3. Do not immerse the main unit into 

water or other liquids.  

4. Do not use abrasive cleaners, 

scouring pads or steel wool.

5. To wash the cooking pot, 

pasta/steamer insert, or the 

poacher/warmer; fill with hot 

water and let it soak. Hand wash 

with a sponge and mild detergent. 

These components are also top 

rack dishwasher safe.

6. Remove the steam vent and clean 

all parts thoroughly and allow to air 

dry before replacing in unit.

7. Lift the carry handle to remove the 

water collector from the rear of the 

unit and hand wash with warm 

soapy water.

8. The cover and inside the main unit 

should be wiped down with a damp 

soapy cloth and then rinsed with a 

clear water cloth.

9. To clean the exterior of the unit, 

lightly wipe with a damp cloth.