Skylink WALL MOUNT TB-318 Leaflet

TM  

Thank you for your purchase of a SkylinkHome Wall Mount Transmitter, 
Model TB-318.  This transmitter allows you to wirelessly operate lighting / 

TM

home automation with the SkylinkHome  receiver modules.  

TM

All wireless signal communications within the SkylinkHome  System are 
based on rolling code technology to ensure highest security is used. 

You will find the following in this package:

- Wall Mount Transmitter
- Mounting Accessories & Double-sided Foam Tape 
- Lithium Battery CR-2032
- User's Instructions

In order to operate a receiver module remotely, a transmitter must be 
programmed to the receiver module. 

To program a transmitter into the receiver module, follow the instructions 
below. 

1. Remove the front wall plate from the Wall Mount 
    Transmitter by loosening the 2 screws.

2. Insert the battery to the Wall Mount Transmitter 
    as shown. Positive side up. When the battery is 
    installed, the red LED on the transmitter will be 
    on for 1 second. 

3. You may transmit the programming signal from the 
    transmitter by pressing the “SET” button on the 
    transmitter. The red LED on the transmitter will be 
    on for 15 seconds. 

4. Put the receiver module that you plan to program 
    into programming mode. Refer to the User's 
    Instructions of that receiver module. 

5. Activate the Wall Mount Transmitter by pressing 
    the pad on the front. Its red LED will flash then off. 

6. Once the transmitter is programmed, the receiver 
    module will quit from programming mode. 

7. Now the programmed transmitter 

 

is ready to be 

    used.

+

CR 2032

Pushing the pad from one position to the other will toggle the status of a 
load, i.e. when the light is off, pushing the pad will turn on the light, and 
vice versa. 

Besides turning on and off a load, you may also control the brightness  
of a light if the receiver module and the light bulb is  dimmable, i.e. either 
incandescent light or dimmable compact fluorescent light.

To change the brightness, first turn on the light by pushing the pad. 

Then, press and hold the pad after the light is on will change the  brightness 
of the light. When the desired brightness is reached, release the pad.

Press and hold the pad again to change the brightness in the opposite way. 
When the desired brightness is reached, release the pad. 

Push 
Down

    20 32

+

        2

+

After programming, you are now ready to install 
the Wall Mount Transmitter . 

You may use double sided foam tape to stick the 
transmitter on the wall, or you may use screws 
to mount the transmitter. 

Using double sided foam tape: 
Place the 2 double sided foam tapes on the back 
of the back plate. Clean the surface of the wall 
where you plan to install the back plate. Peel 
off the foam tape cover and stick it to the wall 
surface. 

Using screws: 
If you are using screws, tighten the back plate of the wall mount trans-
mitter by the 2 screws provided. If you are installing the back plate to an 
existing wall switch with wall box, no need to use the anchors. Other-
wise, drill 2 small pilot holes based on the 2 mounting screw positions 
and insert the anchors before tightening the back plate with screws. 
After securing the back plate, either by double sided foam tape or screws, 
tighten the 2 screws on the front to secure the front plate.