Skylink WALL MOUNT TB-318 Leaflet

The Remote Control is approved by the FCC and it complies with Part 15 of the 
FCC Rules. Its operation is subject to the following two conditions : 
1.  This device may not cause harmful interference.
2.  This device must accept any interference that may cause undesired operation.

WARNING:
Changes or modifications to this unit not expressly approved by the party responsible 
of compliance could void the user’s authority to operate the equipment.

17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email:support@skylinkhome.com
http://www.skylinkhome.com

P/N. 101A396 
Patent Pending
©2010 SKYLINK GROUP

When the operating range is reduced, or when the red LED does not 
flash during operation, it is time to replace the battery. Follow the same 
procedure as installing the battery in section 2 of this manual to replace 
the battery. 

Note: Dispose of old batteries promptly and properly. 

You may erase a transmitter from the receiver module, but you cannot 
erase a specific device directly, you must erase all the wireless devices, 
then program the ones you want to keep.  Follow the instructions below 
to erase programmed transmitters.

1. Power off the receiver module.
2. Press the SET button on the transmitter.
3. Press and hold the programmed pad on the transmitter for at least 2 
    seconds.  Do not release it until step 5.
4. Power up the receiver module, you will hear a beep.
5. You may release the pad on the transmitter.
6. When the pad is release, the receiver will beep, indicating you have 
    successfully erased all the devices from the lighting receiver. 

If you would like to erase a wall mount transmitter from other receiver 
modules, such as WR-001, WE-001, PA-318, PR-318, PL-318, LS-318, 
etc., Please also refer to the user's instructions of that receiver module. 

Note:  The difference between programming a TC remote and 
programming a TB remote is as following:

1. Press the PROG button on the back of a TC remote will activate 
   programming.
2. Press the SET button on a TB transmitter will activate programming.

V1.9

TM

The SkylinkHome  System consists of many other devices such as

TM

SkylinkHome  Remotes, Motion Sensor, ON/OFF Wall Switch, Wall 
Dimmer, Plug-In Dimmer with or without Repeater, Plug-In ON/OFF 
Control (Outdoor/Indoor), Screw-In Dimmer, ON/OFF/Dimming Control, 

TM

ON/OFF Control, Smart Button  Garage Door Control, etc. Please visit 
Skylink website at www.skylinkhome.com for more information.

If, within one year from date of purchase, this product should become defective 
(except battery), due to faulty workmanship or materials, it will be repaired or 
replaced, without charge. Proof of purchase and a Return Authorization are required.

If you would like to 
- find out the up-to-date specifications
- know more about features and applications
- download documents, i.e. user’s instructions
- order Skylink products 

or if you have difficulty getting products to work, please:
1. visit our FAQ section at www.skylinkhome.com, or
2. email us at support@skylinkhome.com, or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.
Fax  (800) 286-1320