BLOOMFIELD Automatic Brewer, Pour-Over Brewer, 8573 w/optional 8900-Series Decanters User Manual

 

 

Page 4 of 4 

CAUTION - CHEMICAL BURN HAZARD 

Deliming chemicals may be caustic.  Wear appropriate protective gloves and 
goggles during this procedure. Never siphon deliming chemicals or solutions by 
mouth. 
 
IMPORTANT: 
This operation to be performed by qualified service personnel ONLY! 

 

IMPORTANT: 
DO NOT spill, splash or pour water or deliming solution into or over any internal 
component other than the inside of the water tank. 

 

IMPORTANT: 
DO NOT allow any internal components to come into contact with the deliming 
solution.  Take care to keep all internal components dry. 
 
PRECAUTIONS:    Disconnect brewer from electric power.  
 

Allow brewer to cool. 

 

FREQUENCY:   

As required (Brewer slow to heat) 

 

TOOLS:   

Deliming Solution 

 

Protective Gloves, Goggles & Apron 

 

Mild Detergent, Clean Soft Cloth or Sponge 

 

Bristle Brush, Bottle Brush 

 

Large Sink (or other appropriate work area) 

 
1.  Disconnect brewer from the electrical supply.  Turn off the water shut-off 
 

valve and disconnect the water supply line from the brewer inlet fitting. 

 
2.  Disconnect faucet plumbing.  Remove the tank lid assembly. 
 
3.  Remove the water tank from the brewer body by lifting straight up.  Empty 
 

all water from the tank.  Set the tank back into the brewer. 

 
4.  Mix 2 quarts of deliming solution according to the manufacturer’s directions.  
 

Carefully pour the deliming solution into the water tank.  Lower the lid 

 

assembly back onto the tank.  Allow to sit for 30 minutes, or as directed by 

 the 

chemical 

manufacturer. 

 

5.  At end of soaking period, remove lid assembly from tank.  Thoroughly rinse 
 

internal components of lid assembly with clear water.  Using a stiff bristle 

 

brush, scrub the heating element to remove lime and calcium build-up.  

 

Rinse with clean water.  Store lid assembly in a safe location. 

 
6.  Remove the tank from the brewer and empty.  Using a stiff bristle brush, 
 

scrub the interior of the water tank to remove lime and calcium build-up.  

 

Rinse with clean water.  

  
7.  Set the tank back into the brewer.  Reassemble faucet plumbing to the tank 
 

lid, and the tank lid to the water tank.  Make sure the gasket is properly in 

 

place, then reinstall the hold-down strap.