Bunn Single SH DBC* (with Smart Funnel) Owner's Manual

Page 31

 

This function allows the operator to track the num-

ber of brew cycles completed. There is one resettable 

counter, and one life counter that is not resettable.

EXIT TO

NEXT FUNCTION

SCREEN

XXXX

            NEXT   RESET

XXXX
NEXT

BREW COUNTERS?

NO                      YES

Procedures to view/reset the brew counters:

1.  Press and hold the ® pad until the display reads 

SET NEW RECIPES. Release the ®.  Press and 

release the ® pad until the display reads BREW 

COUNTERS.

2. Pressing NO in this screen will advance to the next 

function.  Press YES to view the first brew counter. 

This number represents the brew cycles initiated 

since that counter was last reset.

3.  To reset the resettable counter to zero press and 

release RESET when viewing that particular coun-

ter's screen.

4.  To advance to the other counter, press and release 

NEXT. This will advance to  total brews (non-

resettable). 

5.  When finished, press NEXT until the display 

reads BREW COUNTERS. Press and release NO 

to advance to the next function screen, or press 

the 

 pad on the front switch panel to exit the 

BREW COUNTERS function and return to the MAIN 

SCREEN.  

P2448

FUNNEL DETECT?

NO      DONE      YES

1.  Press and hold the ® pad until the display reads  

SET NEW RECIPES. Release the ®.  Press and 

release the ® pad until the display reads FUNNEL 

DETECT.

2.  NO or YES should be flashing to indicate the cur-

rent setting.

3. Select YES to prevent brewing if a Smart Funnel is 

not correctly situated in the rails.  If this function 

is activated and a brew cycle is attempted with the 

funnel not properly situated, the display will read,  

FUNNEL NOT IN PLACE, until one is in place.

4. Select NO to allow brewing without a Smart Fun-

nel in place. This is selected when brewing with a 

funnel other than a Smart Funnel (a regular brew 

funnel).

5.  When finished, press and release DONE. This will 

retain the changes, exit this function screen and 

advance to the next. Another alternative is to press 

the 

 pad located on the front switch panel to 

exit the FUNNEL DETECT and return to the MAIN 

P2309

  This function allows the operator to prevent the 

start of a brew cycle if a Smart Funnel is not positioned 

correctly in the funnel rails.

34025  022509