Bunn Single SH DBC* (with Smart Funnel) Owner's Manual

Page 32

 

This function allows the testing of individual com-

ponents and the ability to check switches for proper 

function. This function also tests the Soft Heat server's 

status on the brewer (in place or removed), and the 

funnel sensor coil's frequency (diagnostic tool for 

troubleshooting purposes only).

EXIT TO

NEXT FUNCTION

SCREEN

EXIT TO

NEXT FUNCTION

SCREEN

PRESS AND RELEASE

® SYMBOL

PRESS AND RELEASE

® SYMBOL

PRESS AND RELEASE

® SYMBOL

NEXT COMPONENT

TO BE TESTED

TEST OUTPUTS?

NO                     YES

TEST SWITCHES?

NO                     YES

BREW VALVE

ON      NEXT      OFF

SERVER REMOVED

              IN PLACE

125.0 KHZ.    4

4     125.0 KHZ.        

NOTHING PRESSED

TEST FREQUENCY?

NO                     YES

TEST SERVERS?

NO                     YES

SERVICE TOOLS?

NO                     YES

P2449

SERVER DETECT ?

NO      DONE      YES

P2310

1.  Press and hold the ® pad until the display reads 

SET NEW RECIPES. Release the ®.  Press and 

release the ® pad until the display reads SERVER 

DETECT.

2. The NO or YES flashes to indicate the current 

selection.

3. Select YES to prevent brewing if the Soft Heat 

server is not correctly positioned on the brewer 

beneath the funnel.  

NOTE: If  YES is selected and a brew cycle is attempted 

with a server not properly placed, the display will read 

SERVER NOT IN PLACE.

4. Select NO to allow brewing without a Soft Heat 

server in place. This is selected when brewing into 

a container other than a Soft Heat Server.

5.  When finished, press and release DONE. This will 

save the new setting, exit the function screen and 

advance to the next. Another alternative is to press 

the 

 pad located on the front switch panel to 

exit the SERVER DETECT function and return to 

the MAIN SCREEN.

 

This function allows the operator to prevent the start 

of a brew cycle if a Soft Heat server is not positioned 

correctly on the brewer.

34025  022509