Source Technologies SECURE MICR PRINTER ST9630 User Manual
Source Technologies, LLC ST9630 Secure MICR Printer User’s Guide
61
Error Message
on Display
Printed
Message
Description
Action
File System
Error Can’t Open
File
Error Can’t Open
File
There was an internal
error while trying to
access flash for audit
trail
error while trying to
access flash for audit
trail
Check that Flash is
installed and not full.
installed and not full.
Flash Full Purge
and Format
and Format
This error message
indicates that the
printer’s flash memory
is full. The audit trail
cannot accept more
jobs until more space is
available in flash.
indicates that the
printer’s flash memory
is full. The audit trail
cannot accept more
jobs until more space is
available in flash.
Press Go then purge the
audit trail. Then either
defragment or format flash
memory (Utilities Menu).
audit trail. Then either
defragment or format flash
memory (Utilities Menu).
Integer string
incorrect length
incorrect length
Integer string
incorrect
length
incorrect
length
A parameter in a
command was not the
correct length.
command was not the
correct length.
Check the Command
(&%STP, STS) for
syntax/numbering errors.
(&%STP, STS) for
syntax/numbering errors.
Invalid
AES/DES key
AES/DES key
Invalid hex digit or
length of decryption
key
length of decryption
key
Check the syntax of
SETAESKEY or
SETDESKEY command.
SETAESKEY or
SETDESKEY command.
Invalid Convert
to Escape
Character
to Escape
Character
Invalid
Convert to
Escape
Character
Convert to
Escape
Character
An error was detected
in the User
Programmable Escape
Character Selection
Command. The
software tried to
specify a NULL or an
ampersand as the first
Escape Character.
in the User
Programmable Escape
Character Selection
Command. The
software tried to
specify a NULL or an
ampersand as the first
Escape Character.
Check the Command
(&%STY...) for errors.
(&%STY...) for errors.
Macro Definition
Error
Error
Invalid
decode mode
specified
decode mode
specified
The Load Flash
Resource Command
contained an invalid
character specifying
the format of the file.
Must be either a D or
S.
Resource Command
contained an invalid
character specifying
the format of the file.
Must be either a D or
S.
Check the Command
(&%STL...) for syntax
errors.
(&%STL...) for syntax
errors.
Macro Definition
Error
Error
Macro ID
greater than
32767 limit.
greater than
32767 limit.
The resource number
in the Load Flash
Resource Command
(&%STL...) was over
the 32767 limit.
in the Load Flash
Resource Command
(&%STL...) was over
the 32767 limit.
Check the Load Flash
Resource Command for
syntax/numbering errors.
Resource Command for
syntax/numbering errors.
Macro Definition
Error
Error
Macro size
exceeds
available
space
exceeds
available
space
Flash resource file size
specified in the Load
Flash Resource
Command is too large
for the available space
remaining in the flash
module.
specified in the Load
Flash Resource
Command is too large
for the available space
remaining in the flash
module.
Format flash memory to
remove all existing
resources or upgrade
flash memory to a larger
module.
remove all existing
resources or upgrade
flash memory to a larger
module.