Sony Water Dispenser 2 User Manual

275

Setup Relating to DCU

  

Ch
apt

er 16 

E

ngin

eering Se

tup

Using any of the following methods, set the serial port connected to the 
VTR for which you want to make the settings.

• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.

Press [Port Setting].

The DCU>Serial Port Assign>VTR Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol, 
serial port name, SCU number, and timecode source appear. In the lower 
part of the status area, the VTR constants appear.

In the <TC Source> group, select the timecode source (reference signal for 
determining the tape position) from the following.

LTC+ (Longitudinal Time Code): Normally LTC is used, but when the 

tape speed is such that LTC cannot be read (

1

/

8

 normal speed or 

below), or the LTC cannot be read for some other reason, this is 
interpolated using CTL pulses or timer counter pulses.

CTL (Control): CTL pulses or timer counter pulses are used. Use this 

only for a tape on which no timecode is recorded.

The displayed tape position is based on the reference signal specified here.

Using any of the following methods, specify the VTR constants.

• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.

Press [Set].

A numeric keypad window for hexadecimal input appears.

1

Port No

Serial port

1 to 30

1

Item

Item selection

1 to 16