Yorkville FH1W Owner's Manual
w w w . y o r k v i l l e . c o m
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA
Canada
Voice: (905) 837-8481
Fax: (905) 837-8746
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA
U.S.A.
Voice: (716) 297-2920
Fax: (716) 297-3689
P
rin
te
d
in
C
an
ad
a
2
Attaching the FH1 Bracket to Enclosures
It’s easiest to mount the FH1 bracket onto the enclosure prior to flying or mounting.
Step 1
Step 1
Preparing the enclosures. Remove the two top and two bottom flyware bolts closest to
the neighboring side of each enclosure to be conjoined.
Step 2
Bracket Assembly. Assemble the FH1 bracket as shown in the diagram. Assemble this
on a flat surface.
i. Place the two shackle Cross Members side-by-side (as shown in figure 2a).
ii. Mount Cross Member Support ends of the mated Cross Members (as shown
ii. Mount Cross Member Support ends of the mated Cross Members (as shown
in figure 2b).
iii. Slip the Support Plates into the slots (both ends) created by the mating of the
Shackle Cross Members and the Cross Member Support (as shown in figure 2c).
Tip: it’s easiest to assemble FH1 Bracket apart from the enclosure, either on a table or the top of the enclo-
sure. Use the supplied bolts to align the Support Plates, The Shackle Cross Members and the Cross Member
Support when moving the assembled FH1 bracket.
Flyware Bracket System
FIGURE 2a
FIGURE 2b
FIGURE 2c
FIGURE 1