ZyXEL Communications Plumbing Product metrogigabit switch User Manual

Chapter 32 PPPoE

MGS3700-12C User’s Guide

Use this screen to configure PPPoE IA settings that apply to a specific VLAN on a 
port. Click Advanced Application > PPPoE > Intermediate Agent > Port > 
VLAN to display the screen as shown.

Figure 163   Advanced Application > PPPoE > Intermediate Agent > Port > VLAN 

The following table describes the labels in this screen. 

Table 109   Advanced Application > PPPoE > Intermediate Agent > Port > VLAN

Show Port

Enter a port number to show the PPPoE Intermediate Agent settings for 
the specified VLAN(s) on the port.

Show VLAN

Use this section to specify the VLANs you want to configure in the section 
below.

Start VID

Enter the lowest VLAN ID you want to configure in the section below.

End VID

Enter the highest VLAN ID you want to configure in the section below.

Apply

Click Apply to display the specified range of VLANs in the section below. 

Port:

This field displays the port number specified above.

VID

This field displays the VLAN ID of each VLAN in the range specified above. 
If you configure the * VLAN, the settings are applied to all VLANs.

*

Use this row to make the setting the same for all VLANs. Use this row first 
and then make adjustments on a VLAN-by-VLAN basis. 

Note: Changes in this row are copied to all the VLANs as soon as 

you make them. 

Circuit-id

Enter a string of up to 63 ASCII characters that the Switch adds into the 
Agent Circuit ID sub-option for PPPoE discovery packets received on this 
VLAN on the specified port. Spaces are allowed. 

The Circuit ID you configure for a specific VLAN on a port has the highest 
priority.