ZyXEL Communications Plumbing Product metrogigabit switch User Manual

 Chapter 32 PPPoE

MGS3700-12C User’s Guide

Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN 
and whether the Switch appends the Circuit ID and/or Remote ID to PPPoE 
discovery packets from a specific VLAN. Click Advanced Application > PPPoE > 
Intermediate Agent > VLAN to display the screen as shown.

Figure 164   Advanced Application > PPPoE > Intermediate Agent > VLAN 

The following table describes the labels in this screen. 

Remote-id

Enter a string of up to 63 ASCII characters that the Switch adds into the 
Agent Remote ID sub-option for PPPoE discovery packets received on this 
VLAN on the specified port. Spaces are allowed.

If you do not specify a string here or in the Remote-id field for a specific 
port, the Switch automatically uses the PPPoE client’s MAC address.

The Remote ID you configure for a specific VLAN on a port has the highest 
priority.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The 
Switch loses these changes if it is turned off or loses power, so use the 
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 109   Advanced Application > PPPoE > Intermediate Agent > Port > VLAN 
(continued)

Table 110   Advanced Application > PPPoE > Intermediate Agent > VLAN

Show VLAN

Use this section to specify the VLANs you want to configure in the section 
below.

Start VID

Enter the lowest VLAN ID you want to configure in the section below.