Vortech Engineering Nissan 350Z/Infinity G35Supercharger System 2003-2006 User Manual

P/N: 4NZ020-010

©2007 Vortech Engineering, LLC

All Rights Reserved, Intl. Copr. Secured

12JAN07 v4.0 Nissan 350Z(4NZv4.0)

12

A.

Remove the wire loom hold-downs from the

front of the radiator core support. Remove the

brackets securing the power steering cooler

lines to the core support.

• G35 Vehicles, All: Remove the foam

inner bumpers on the driver and passen-

ger sides of the Charge Air Cooler mount-

ing location. Locate and remove the power

steering hard line brackets. Cut the thread-

ed section off of the bracket just removed.

Install the threaded piece behind the core

support and clamp the hard lines to the

front of the core support as shown in

Fig. 8-a.

• G35 Vehicles, Automatic Only: Remove

the two rubber lines from the transmission

cooler. Remove the two rubber transmis-

sion cooler lines from the junction on the

passenger’s side frame rail. Remove the

hard lines with the rubber lines still

attached from the vehicle. Once the trans-

mission cooler has been repositioned,

connect the cooler to the junction using

the rubber line provided. Secure with facto-

ry clamps.

B.

Using the supplied adhesive backed foam to

insulate the power steering cooler from the

radiator, position it as shown in Fig. 8-b.

Install the snap connectors on the free end.

Cut off any excess that would interfere with

radiator fan operation.

C.

Rotate any clamps that are pointing toward

the front of the vehicle so that they will not

contact the charge air cooler. Use the sup-

plied zip-ties to secure the wire loom to the

air temp sensor and the power steering hose.

D.

Temporarily attach the two supplied matching

metal brackets to the bottom of the radiator

core support using two of the factory splash

pan screws. (See Fig. 8-c.)

E.

Attach the remaining metal bracket to the

charge cooler using the supplied 1/4" x 3/4"

hardware. (See Fig. 8-d.)

F.

Install the cooler in front of the radiator and

rotate the metal brackets to support it as

shown.

G.

Mark the plastic panels on either side of the

cooler for passage of the Ø2-1/2" cooler

tubes. Remove the cooler and drill a horizon-

tal 2.5" hole (minimum) through each of the

plastic panels. (If the vehicle has foam blocks

that interfere with the discharge ducts,

remove the foam from the vehicle.)

H.

Reinstall the cooler. Connect the upper cooler

bracket to two of the factory screws that

secure the front bumper. Align cooler for best

fit and tighten the four screws that attach the

bracket.

8.

CHARGE COOLER INSTALLATION

Fig. 8-b

Fig. 8-a

SECURE WIRE LOOM HERE

Fig. 8-d

Fig. 8-c