Vortech Engineering Nissan 350Z/Infinity G35Supercharger System 2003-2006 User Manual

11

Cut the FMU line that goes to the vehicle’s
FUEL TANK and install a 5/16" TEE fitting
with clamps. Connect the TEE to the INLET
of the supplied fuel pump. (See Fig. 7.2-c.)

Cut the FMU line that goes to the vehicle’s
ENGINE and install a 5/16" TEE fitting with
clamps. Connect the TEE to the OUTLET of
the supplied fuel pump.

Remove the vacuum cap from the small
bump tube on the front passenger’s side on
the intake manifold. Use the supplied vacuum
hose to connect the pump tube to the fitting
on the FMU cover. (See Fig. 7.2-d.)

Install a short length of vacuum hose onto the
protruding roll-pin that is installed into the
FMU body. Use a small amount of sealant
and route and secure the hose so that the
open end is pointed towards the ground to
minimize water entrance. (See Fig. 7.2-c.)

MARK AND DRILL HOLES INSTALL

 THE SUPPLIED SHEET METAL SCREWS TO HOLD

THE FUEL MANAGEMENT UNIT AND FUEL PUMP

CUT SUPPLIED FUEL HOSE

TO LENGTH (~39")

FACTORY SUPPLY

LINE FROM FUEL

TANK

5/16" HOSE

BARB TEES

5/32" VENT

HOSE (~8")

~18"

(VERIFY THAT

COPPER WASHERS

ARE INSTALLED AND

FITTINGS ARE TIGHT)

RED WIRE WITH STRIPE (FROM

IGNITION TIMING CONTROL BOX)

FACTORY FLEXIBLE LINE

TO INTAKE MANIFOLD

SUPPLIED

FUEL PUMP

INSTALL AND

TIGHTEN CLAMPS

USING STEPLESS

CLAMP PLIERS

5/32" HOSE

(CONNECTED

TO MANIFOLD

PRESSURE)