Viking Huskylock 936 User Manual

—7—

Cut the thread

Tie the thread

Presser
foot lift

Presser foot

Eye of the needle

The machine comes threaded with overlock 

thread. To change thread follow the easy 

threading as explained on page 16~18 or to tie 

on:

1. Cut the thread in use near the thread spool 

(in front of the telescopic thread stand). Place 

the new thread spool on the spool pin and tie 

the thread ends together.

2. Raise the presser foot with the presser foot 

lift up to release the thread tension, so the 

knot can easily pass through the thread ten-

sion discs.

3. Pull out the looper thread until the thread 

knot comes about 10 cm (3” to 4”) behind the 

presser foot.

4. When changing the needle thread, cut the 

thread knot before it reaches the eye of the 

needle to avoid bending the needle.

In some cases cover the spool with the net 

to prevent threads from slipping off the spool. 

Slide on the net so that it covers the spool 

entirely.

When using standard thread spools, place the 

spool holders as shown to hold spool in place.

And prevent thread from getting caught on edge 

of spool.

A

B