Unisys EFP9800 Series User Manual
Diagnostics and Print Tests
3–26
3255
4073–002
5. Press the Paper Feed button.
The printer prints the letter indicating the relative noise level on the receipt.
6. Repeat by pressing the Paper Feed button again.
When finished, turn the printer off and reset the DIP switches to what they
were when you started.
were when you started.
7. For normal operation settings, see “Switch Settings” in section 5.
8. Turn the printer back on.
Selecting the Font for the MICR Check Reader
Use this procedure to select the font for the MICR check reader to read. There
are two fonts that the EFP9800 printer is able to recognize. However, the
switches must be set to the font that will be read.
are two fonts that the EFP9800 printer is able to recognize. However, the
switches must be set to the font that will be read.
Note: The EFP9800 FLASHADMIN software utility can also be used for
MICR font selection. This utility is included in the EFP9800-SW1
style package.
style package.
Note: Secure the roller assembly in a closed position to eliminate the
nuisance noise from occurring when the receipt take-up assembly is
not being used.
not being used.
Caution
The DIP switches are set at the factory to predetermined settings. Change the
settings carefully to avoid changing other functions.
settings carefully to avoid changing other functions.
1. Turn the printer off.
2. Turn the printer to the back to access the DIP switches and write down the
current switch settings.