Xerox Saw 5335 User Manual

The grounding prong in the plug is con-

nected through the green wire inside the

cord to the grounding system in the tool.

The green wire in the cord must be the

only wire connected to the tool's ground-

ing system and must never be attached to

an electrically live terminal.
Your tool must be plugged into an appro-

priate outlet, properly installed and

grounded in accordance with all codes and

ordinances. The plug and outlet should look

like those in Figure A.

Double Insulated Tools:

Tools with Two Prong Plugs
Tools marked Double Insulated do not re-

quire grounding. They have a special

double insulation system which satisfies

OSHA requirements and complies with the

applicable standards of Underwriters Labo-

ratories, Inc., the Canadian Standard As-

sociation and the National Electrical Code.

Double Insulated tools may be used in ei-

ther of the 120 volt outlets shown in

Figures B and C.

Grounded Tools:

Tools with Three Prong Plugs
Tools marked Grounding Required have

a three wire cord and three prong ground-

ing plug. The plug must be connected to a

properly grounded outlet (See Figure A). If

the tool should electrically malfunction or

break down, grounding provides a low re-

sistance path to carry electricity away from

the user, reducing the risk of electric shock.

Fig. B

Fig. C

Fig. A

Improperly connecting the

grounding wire can result in the

risk of electric shock. Check

with a qualified electrician if you

are in doubt as to whether the

outlet is properly grounded. Do

not modify the plug provided

with the tool. Never remove the

grounding prong from the plug.

Do not use the tool if the cord or

plug is damaged. If damaged,

have it repaired by a MILWAUKEE

service facility before use. If the

plug will not fit the outlet, have a

proper outlet installed by a quali-

fied electrician.

GROUNDING

WARNING!

SPECIFIC SAFETY RULES

1. Hold power tools by insulated gripping surfaces when performing an opera-

tion where the cutting tool may contact hidden wiring or its own cord. Contact

with a live wire will make exposed metal parts of the tool live and shock the operator.

2. Maintain labels and nameplates. These carry important information. If unreadable

or missing, contact a MILWAUKEE service facility for a free replacement.

3. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other

construction activities contains chemicals known to cause cancer, birth defects or

other reproductive harm. Some examples of these chemicals are:
lead from lead-based paint
crystalline silica from bricks and cement and other masonry products, and
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of

work. To reduce your exposure to these chemicals: work in a well ventilated area, and

work with approved safety equipment, such as those dust masks that are specifically

designed to filter out microscopic particles.

4. Wear ear protectors. Exposure to noise can cause hearing loss.
5. Use auxiliary handles supplied with the tool. Loss of control can cause personal

injury.

FUNCTIONAL DESCRIPTION

1. Hammer iron
2. Dust shield
3. Side handle

knob

4. Trigger
5. Cord
6. Side handle

Blows per

Minute

1 600

Volts

120

Catalog

Number

5335

Specifications

Amps

Blow

Energy

18.5 ft.-lbs.

Accessory

Size

3/4"

Canadian Standards

Association

Underwriters

Laboratories, Inc.

Volts Alternating Current

BPM

Blows per Minute

Symbology

Amperes