System Sensor PDRP-1001 User Manual

PDRP-1001 Instruction Manual  PN 50734:D0  04/06/01

13

Carefully unpack the system and check for shipping damage.

Select a suitable location in a clean, dry, vibration-free environment that is not subject to extreme 
temperatures. Locate the top of the cabinet approximately five feet above the floor with the hinge on the 
left. The panel must be easily accessible for maintenance; the hinged door requires a minimum clearance 
of 14 in. (35.56cm) to open.

To prevent damage to the printed circuit board it should be removed prior to mounting of cabinet. 

Securely mount the cabinet using the mounting holes provided. 

Select and remove knockouts according to the number of conduits required.

Attach conduits to backbox as required.

Determine the number of conductors required for the devices to be employed. Pull required conductors 
into the box through the knockouts provided.

Note: All wiring should be in accordance with the National and/or Local codes for fire alarm systems, including 
"Power-limited Wiring Requirements" on page 17.

1

Disconnect the transformer wires from the circuit board at the J1 
connector.

2

Remove the four (4) phillips head screws securing circuit board to 
backbox rails.

3

Carefully set board aside in a secure place.

1

Mark and predrill holes for the top two keyhole mounting screws using the 
dimensions shown in Figure 2 on page 14.

2

Install two upper screws in the wall with the heads protruding.

3

Using the upper keyholes, mount the backbox over the two screws.

4

Mark and drill the lower two holes.

5

Secure backbox by installing the remaining fasteners and tightening all 
screws.

6

If required, attach optional Trim Ring (TR-4XR) using the provided 
instructions.