SMART Technologies Board Software 9.5 User Manual

7

SMART used the Install Shield installation utility to install SMART Board software versions 8.x. To 

remove these versions of software silently, you must create a setup.iss file.

Before you can perform the following procedures, you must obtain the product code for your 

version of SMART Board software. Refer to the following table for the ProductCode value to use 

for these versions of software:

NOTE: Include the braces—"{" and "}"—when using a ProductCode in the following commands.

You only need to create the initial setup.iss file once. You can then use this setup.iss file to 

remove the same version of SMART Board software from other computers on your network. 

1. Check the version of SMART Board software that are installed on your computers. Refer to the 

table above to identify the product code you must use in the following commands.

2. Click Start > Run and type CMD into the Open field.

A DOS window opens.

3. Type

ProductCode /l1033 /r /z-AddRemove -RemoveReg 

and click OK.

This command removes the SMART Board software and creates a setup.iss file in the root of 

the Windows folder. 

4. Place the setup.iss file on a network server where all computers can access it.

1. Go to each computer and click Start > Run and type CMD into the Open field.

A DOS window opens.

2. Type 

ProductCode /l1033 /s /z-AddRemove -RemoveReg /

"path to the setup.iss file\setup.iss" /f2"destination path for the 

uninstall log file\uninst.log"

and click OK.

8.0.0

{7823065C-AA64-425D-A9A3-18BF7B99E944}

8.0.1

{F414173A-7BE1-46C6-811A-51277A4D9E7B}

8.1.0

{155FBC4E-CF09-4698-961B-DF9787E6B8B8}

8.1.1

{7AD771BB-B681-4659-B7FA-223FCB1FDF56}

8.1.2

{55C574CA-8D71-46F1-9897-98DAE55C0394}

8.1.3

{10D2A154-D221-4455-8426-E67D12C092F9}

8.1.4

{41CEFD25-0D33-44EA-A19C-5A1EBABFC041}