Sierra Wireless RAVEN 1X 20070914 User Manual
Configuration Commands
Rev 3.0B Feb.08
114
•
n=0 : Allow only the IP address specified in S53 to connect
when UDP auto answer is enabled (S82=2).
when UDP auto answer is enabled (S82=2).
•
n=1 : Allow any incoming IP address to connect when
UDP auto answer is enabled (S82=2).
UDP auto answer is enabled (S82=2).
Note: Always subject to any Friends filters that may be defined.
HOR=n
Half‐Open Response ‐ In UDP auto answer (half‐open) mode.
•
n=0 : No response codes when UDP session is initiated.
•
n=1 : RING CONNECT response codes sent out serial link
before the data from the first UDP packet.
before the data from the first UDP packet.
Note: Quiet Mode must be Off.
MDhh
Default power‐up mode for the serial port: When the Raven
modem is power‐cycled, the serial port enters the mode
specified by this command after 5 seconds. On startup, typing
ATMD0 within 5 seconds changes the mode to normal (AT
command) mode. See also S53 to set the port for UDP or TCP.
modem is power‐cycled, the serial port enters the mode
specified by this command after 5 seconds. On startup, typing
ATMD0 within 5 seconds changes the mode to normal (AT
command) mode. See also S53 to set the port for UDP or TCP.
•
hh (hex byte)=00 : normal
•
hh=01 : SLIP
•
hh=02 : PPP
•
hh=03 : UDP
•
hh=04 : TCP
•
hh=07 : PassThru
•
hh=0F : PinPoint MDT
•
hh=13 : Modbus ASCII
•
hh=23 : Modbus RTU (Binary)
•
hh=33 : BSAP
•
hh=63 : Variable Modbus
•
hh=73 : Reliable UDP
•
hh=83 : UDP Multicast
S82=n
Enables UDP auto answer (half‐open) mode.
•
n=0 : Normal mode
•
n=2 : Enable UDP auto answer mode.