Satco Products CF230E-B User Manual
Heat & Glo • CF230E-B & CF260E-B • 4038-894 Rev C • 11/05
5
2
Getting Started
A. Design and Installation Considerations
Check building codes prior to installation.
• Installation MUST comply with local, regional,
• Installation MUST comply with local, regional,
state and national codes and regulations.
•
Consult insurance carrier, local building inspector,
fi re offi cials or authorities having jurisdiction about
restrictions, installation inspection, and permits.
fi re offi cials or authorities having jurisdiction about
restrictions, installation inspection, and permits.
CAUTION
When planning a heater installation, it is necessary to deter-
mine the following information before installing:
mine the following information before installing:
• Where the heater is to be installed. See Sections
3 and 4.
• Electrical wiring. See Section 4.
• Framing and fi nishing details. See Sections 3 and 6.
•
• Framing and fi nishing details. See Sections 3 and 6.
•
Whether optional accessories—devices such as a fan, wall
switch or remote control —are desired. See Section 10.
switch or remote control —are desired. See Section 10.
Reciprocating saw
Framing material
Pliers Wall-fi
nishing
materials
Hammer Gloves
Phillips screwdriver
Phillips screwdriver
Framing square
Flat blade screwdriver
Electric drill and bits
Plumb line
Safety glasses
Level Tape
measure
Surround
1/2-3/4 in. length, #6 or #8 self-drilling screws
Misc. screws and nails
1/2-3/4 in. length, #6 or #8 self-drilling screws
Misc. screws and nails
• Keep heater dry.
• Mold or rust may cause odors.
• Mold or rust may cause odors.
CAUTION
C. Inspect Heater and Components
• Carefully remove the heater and components from the
packaging.
• Report to your dealer any parts damaged in shipment.
•
•
Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.
Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.
Fire Risk
Inspect heater and components for damage.
Damaged parts may impair safe operation.
• Do
Damaged parts may impair safe operation.
• Do
NOT
install
damaged
components.
• Do NOT install incomplete components.
• Do
• Do
NOT
install
substitute
components
Report damaged parts to dealer.
WARNING
Sharp Edges
• Wear
• Wear
protective
gloves
and safety glasses during
installation.
installation.
CAUTION
Note: Minimum and maximum clearances must be
maintained at all times. Illustrations throughout these
instructions refl ect typical installations and are for design
purposes only. Actual installation may vary slightly due to
individual design preferences.
maintained at all times. Illustrations throughout these
instructions refl ect typical installations and are for design
purposes only. Actual installation may vary slightly due to
individual design preferences.
The illustrations and diagrams used throughout these
installation instructions are not drawn to scale.
installation instructions are not drawn to scale.
B. Tools and Supplies Needed
Before beginning the installation be sure the following tools
and building supplies are available:
and building supplies are available: