Satco Products CF230E-B User Manual

Page of 26
Heat & Glo • CF230E-B & CF260E-B • 4038-894 Rev C • 11/05
6
3  
Framing and Clearances 
A. Selecting Heater Location
Several options are available to you when choosing a loca-
tion for your heater. This heater may be used as a room 
divider, installed along a wall, across a corner or used in an 
exterior chase. See Figure 3.1. This heater may be installed 
directly on the fl oor, carpet or raised on a hearth.
Fire Risk
Provide adequate clearances.
•  Around air openings
• To 
combustibles
• For 
service 
access.
Locate heater away from traffi c areas.
WARNING
Note:
•  
Illustrations and photos refl ect typical installations 
and are FOR DESIGN PURPOSES ONLY.
  Illustrations/diagrams are not drawn to scale.
  Actual installation/appearance may vary due to 
individual design preference.
•  Hearth & Home Technologies reserves the right to 
alter its products.
B. Clearances
Figure 3.1 shows all clearances that must be maintained 
around the heater.
Fire Risk
Due to high temperature, this 
heater
 should 
be located out of high traffi c areas.
•  Keep combustible materials such as 
furniture, pillows, bedding, papers, 
clothes and curtains at least 12 in. 
(305  mm) from the front of the 
heater
.
WARNING
Electrocution Risk
•  NEVER locate this 
heater
 where it may fall 
into a bathtub or other water container.
DANGER
Fire Risk!
•  Prevent contact with sagging, loose 
insulation.
•  Do NOT install against vapor barriers or 
exposed insulation.
WARNING
Do NOT use this 
heater
 if any part has been under water. 
Immediately call a qualifi ed service technician to inspect 
the 
heater
 and to replace any part of the control system  
which has been under water.
WARNING