Pioneer SC-1525-K User Manual

En

Most components can be assigned to one of the input 
function buttons (such as DVD or CD) using the 
component’s manufacturer preset code stored in the 
remote.

However, there are cases where only certain functions 
may be controllable after assigning the proper preset 
code, or the codes for the manufacturer in the remote 
control will not work for the model that you are using.

If you can’t find a preset code that matches the 
component you want to control, you can still teach the 
remote individual commands from another remote 
control (see Programming signals from other remote 
controls on 

page 68).

• For greater convenience, assign the TV connected to 

the MONITOR OUT terminal to the TV CTRL button, 
and assign your satellite/cable receiver or set-top box 
connected to the TV input terminal to the TV input 
button. If a single device is connected to both 
terminals, that device should be assigned to both the 
TV CTRL and TV input buttons.

• Devices may be assigned to the following input 

function buttons.

seconds.
The LED flashes continuously.

• To cancel the preset setup mode press R.SETUP.

you want to control.
When assigning preset codes to TV CONTROL, press TV 
CTRL here.

The LED blinks once and flashes continuously.

code.
See Preset code list on page 107.

If the LED lights for one second, the setting has been 
successfully completed.

When the preset code is fully input, the LED flashes three 
times to indicate that the setting has failed. If this 
happens, enter the 4-digit preset code again.

you want to control.
To try out the remote control, switch the component on or 
off (into standby) by pressing 

 SOURCE. If it doesn’t 

seem to work, select the next code from the list (if there 
is one).

If the preset code for your component is not available, or 
the available preset codes do not operate correctly, you 
can program signals from the remote control of another 
component. This can also be used to program additional 
operations (buttons not covered in the presets) after 
assigning a preset code.

1

Certain buttons represent operations that cannot be 
learned from other remote controls. The buttons 
available are shown below:

seconds.
The LED flashes continuously.

• To cancel the preset setup mode press R.SETUP.

you want to control.
The LED blinks once and flashes continuously.

1   The  remote can store about 120 preset codes from other components (this has been tested with codes of Pioneer format only).

SC-1525_UXJCB.book  68 ページ  ２０１０年４月２０日　火曜日　午後７時３２分