Pelco PelcoNet Multimedia Transmission Via Network Net350 User Manual

C2907M-D (4/05)

CONNECTION SCENARIO 3 – USING A CM9760-KBD

Refer to Figure 53 and the instructions that follow.

Figure 53. CM9760-KBD Connected to a CM9700-CC1 Controller

1. Connect a DB9 cable to the COM1 port on the back of the NET350 receiver. (In the Interface Mode field on the configuration page for the COM1

interface settings, select RS-232.) The data format must be 4800baud, 8 data bits, even parity, and 1 stop bit.

2. On the receiver side, connect TX- on the DB9 cable to terminal 7 on the wall block. Connect TX+ on the DB9 cable to terminal 8 on the wall

block. Connect RX- on the DB9 cable to terminal 2 on the wall block. Connect RX+ on the DB9 cable to terminal 1 on the wall block.

3. Connect an RJ-45 straight cable from the wall block to the power pack.

4. Connect an RJ-45 straight cable from the keyboard input connector on the power pack to COM 1 on the keyboard.

5. Connect the monitor.

6. Refer to Figure 50 and Figure 53. Splice the supplied DB9 cable into the CM9760-CC1 wall block. Connect TX- from the NET350 transmitter

to terminal 2 on the wall block, TX+ to terminal 1, RX- to terminal 7, and RX+ to terminal 8.

7. Plug the DB9 cable into the COM1 port on the transmitter. (In the Interface Mode field, select RS-232.) The data format must 4800, 8, even, 1.

8. Connect an RJ-45 flipped cable from the wall block to Sercom port 5 on the CC1’s rear panel.

RECEIVER

Video In

Audio I/O

COM2:
RS232

COM1:

RS232/422/485

Power

12 VDC

4800, 8, EVEN, 1

FLIPPED

CABLE

TRANSMITTER

PV130

TX(-)

TX(+)

RX(-)

RX(+)

SERCOM PORT PROGRAMMED FOR KBD

CM9700-CC1

Video Out