Troy-Bilt CSV 206 Chipper Shredder Vac User Manual

2. 

Pull spring loaded pin out on the base and align pin with 

the first hole (closest to the end of the tube) in the hose 

adapter. See Figure 3-4B.

3. 

Release the pin to lock the hose in place.

4. 

Lay hose tubing in curved end of hose handle next to 

chipper chute and into hose cradle. See Figure 3-5A & B.

5. 

Snap the hose handle first into the upper hose handle 

bracket and then into the lower hose handle bracket. See 

Figure 3-5C.

4. 

Pull the two cable ties attached to the cables tight 

approximately 8 inches from each cable end and place the 

cables into the cable guide.

5. 

Loosen the wing nut that secures the rope guide to the 

right side of upper handle.

a.  Slowly pull starter rope out of engine.
b.  Slip the starter rope into the rope guide. See Figure 

3-3.

c.  Tighten the wing nut.

1. 

Slide hose adapter of hose assembly into the base adapter 

located on the left front of the chipper shredder vacuum. 

See Figure 3-4A.