Troy-Bilt CSV 206 Chipper Shredder Vac User Manual

The nozzle can be adjusted to any six positions, ranging from 

5/8” to 4 1/8” ground clearance. The nozzle height has to be 

adjusted according to chipper shredder conditions.
1. 

Depress nozzle height adjustment lever towards wheel. 

See Figure 3-7.

2. 

Move the height adjustment lever forward or backward to 

adjust the nozzle upwards or downwards. Make sure both 

levers are in the same position.

3. 

Release lever towards deck. See Figure 3-7.
NOTE: In general, raise the nozzle height to vacuum a 

thick layer of leaves. Lower the nozzle height for smoother 

surfaces.

Refer to the separate engine owner’s manual for additional 

engine information.
1. 

Add oil provided before starting unit for the first time out 

of the box. 

2. 

Service the engine with gasoline as instructed in the 

separate engine owner’s manual.

Use extreme care when handling 

gasoline. Gasoline is extremely flammable and the 

vapors are explosive. Never fuel the machine 

indoors or while the engine is hot or running. 

Extinguish cigarettes, cigars, pipes and other 

sources of ignition.

Never fill fuel tank indoors with engine 

running or until the engine has been allowed to cool 

for at least two minutes after running.

1. 

Grasp bag handle with one hand and slide locking rod on 

mounting bracket with other hand toward engine. Use 

the end of mounting bracket as leverage when sliding the 

locking rod. See Figure 3-6.

2. 

Slip bag over the rim of the discharge opening and release 

locking rod to secure bag in place. 

3. 

Snap bag clip to the top of the lower handle.

4. 

Place the lower straps on the bag over the top of lower 

handle, hooking them on the studs. See Figure 3-6.
NOTE: The bag/chute switch button attached to the 

mounting bracket must be fully depressed by the tip of 

front tab on bag handle when securing the bag or engine 

will not start.