Tippmann Games 98 Custom User Manual

1) Receiver Disassembly

To remove the left-side receiver, unscrew all (6) receiver
connection bolts.  Then carefully lift the left-side receiver
to access the internals.

Note:

The Safety will stay on the left-side receiver and

should be reassembled the same way.

Once inside, pull the end cap out to remove the drive
spring guide pin and drive spring.  These parts must be
removed before the bolt handle will release.  Disconnect
the linkage arm from the rear and front bolts.  Slide the
front bolt off the power tube and check the o-ring.  Clean
and oil the o-ring or if damaged, replace with a new one.
Do the same with the rear bolt o-ring.

14

Power tube and valve removal.

Note:

Do not remove the gas line fitting unless it is
leaking or you need to replace the valve.  If
you should do so you will need some teflon
tape or paste to reinstall it.

To release the power tube and valve, unscrew the two
valve bolts on the outer right-side receiver.

When Reinstalling:  Do not over tighten bolts when
reinstalling.

Valve removal from power tube:  If it is necessary to
remove the valve, use a wrench to slowly unscrew the
gas line fitting.  Once the fitting is out, the valve will slide
out the back of the power tube.

Note:

Check the external valve o-ring at this time.
If the o-ring is damaged your gun will not
function correctly.

To reinstall valve: insert valve into power tube, align
holes and with teflon tape or paste on gas line fitting
threads, slowly screw into valve and snug with wrench.

15