Manualsbrain.com
  1. Manuals
  2. Brands
  3. Telefunken
  4. L22F137D2
  5. User Manual

Telefunken L22F137D2 User Manual

Download
Page of 55
English   - 26 -
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward 
gently.
2. Install two AAA batteries. Make sure to match the + 
and - ends of the batteries in the battery compartment 
(observe the correct polarity.
3. Replace the cover.
+
+
- -
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on 
220-240V AC, 50 Hz socket. After unpacking, allow 
the TV set to reach the ambient room temperature 
before you connect the set to the mains. Plug the 
power cable to the mains socket outlet.
SPDIF
VGA
Aerial or Cable
 
Switching On/Off
To Switch the TV On
• Connect the power cord to the 220-240V AC, 50 
Hz socket.
• Switch the “
” button on the rear left hand side 
to position “|” so the TV will switch to standby mode. 
Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the “ ” button,P+/P- or a numeric button on 
the remote control.
b. Press the middle of the “
” button on the TV.
By either method the TV will switch on.
Switching the TV Off
• Press the “ ” button on the remote control or press 
the “
” button, so the TV will switch to standby 
mode.
Switch the “
” button to position 2 as illustrated, 
 so the TV will switch OFF.
To turn off the TV completely, remove the power 
cord plug from the mains power socket.
Note: When the TV is switched to standby mode, standby 
LED can blink to indicate that features such as Standby 
Search, Over Air Download or Timer is active. The LED 
can also blink when you switch on the TV from standby 
mode.
First Time Installation
When  turned  on  for  the  first  time,  the  “language
selection” menu appears. The message “
Welcome 
please select your language!” is displayed in all 
language options listed alphabetically. 
Press the “
” or “
” button to highlight the 
required language, press 
OK button to select. “First 
Time Installation” appears. Use “   ” or “ ” button to 
set the required country, and press “
” button to 
select Search Type (optional). 
Use “ ” or “  ” to set the desired search type. Available 
search types are Digital and analog, digital only and 
analog only. 
When set, press “
” to select Teletext Language. 
Use “  ” or “ ” to select the desired Teletext Language. 
Next, select 
Scan Encrypted and set as Yes if you 
want to scan coded stations.
Press 
OK button on the remote control to continue 
and the following message will be displayed on the 
screen.