Oce North America TDS600 User Manual
272
Océ TDS600 Multifunctional Digital System User Manual
Note:
If the material cannot be removed easily, you must open the cover of
the fusing section to get access to the jammed material. Otherwise, the
OPC drum may become damaged.
OPC drum may become damaged.
3
Close the manual feeder again.
Paper jam in the fuser section
The fusing section is indicated as section D (see figure 163 on page 270).
Caution:
During normal use the fuser must be closed. Only open it to
remove paper after a media jam. Because of hot surfaces the operator
always has to be cautious and wear heat-protective gloves, when removing
printing material in the fuser section.
always has to be cautious and wear heat-protective gloves, when removing
printing material in the fuser section.
▼
▼
▼
▼
How to clear a jam in the fuser section
1
Switch off the printer.
2
Wait a few moments to let the fuser cool down.
3
Open the manual feeder to release the printing material.
Attention:
If you fail to do so, the OPC drum might get damaged when you
remove jammed material.
4
Open the cover on the left side (see figure 166).
Note:
During normal use the left cover has to be closed. This is necessary to
ensure proper operation.
[166] Opening the left side cover