Kidde Fire Systems VEGA LT TM0081 User Manual
TM0081
Page 44 of 51
Issue 1.01
Paper Replacement
1.
Open the panel outer door to gain access to the printer assembly.
2.
Remove the paper pivot bar by unscrewing the knurled thumbscrew and withdrawing the paper pivot
bar.
bar.
3.
Remove any old paper and the cardboard roller from the paper pivot bar and discard.
4.
Locate the paper roll in the paper holder and insert the first 20-mm (approx.) of paper by hand in the slot
provided in the back of the printer assembly. Note, the paper is loaded the opposite way to the way it is
rolled and is automatically detected by the printer and fed through to the opposite side of the
mechanism.
provided in the back of the printer assembly. Note, the paper is loaded the opposite way to the way it is
rolled and is automatically detected by the printer and fed through to the opposite side of the
mechanism.
5.
Fasten paper pivot bar in position with the knurled thumbscrew.
6.
Close the panel outer door and secure.
7.
The event printer is now ready for use.
12.4
VEGANET NETWORK CARD - Part Number VN2107
Installation
1.
Ensure that the control panel is powered down. Disconnect the stand-by battery and mains then the
supply.
supply.
2.
Install the 29-020527-001 card using the fixings supplied above the MBLC card as shown in Figure 39.
Figure 39: Network Interface Card Installation
3.
Using the 10-way ribbon cable supplied with the network card, connect PLG 2 to the MBLC card PLG 9.
4.
Connect the supply cables (5v, 0v) located at TB1 on the network card to the supply output terminals
located on the MBLC card at TB 8.
located on the MBLC card at TB 8.
5.
Connect the external network transmission cables to other panels located on the network as shown in
Figure 40.
Figure 40.