Jenn-Air Ice Maker W10519943B User Manual

To order accessories, in the U.S.A., visit our web site www.jennair.com/accessories or call 1-800-536-6247.

In Canada, visit our web site www.whirlpoolparts.ca or call 1-800-807-6777.

Order Part Number 

F2WC9I1

or ICE2

Order Part Number 4396808

In U.S.A., order Part Number W10355016

In Canada, order Part Number W10355016B

In U.S.A., order Part Number W10355049
In Canada, order Part Number W10355049B

In U.S.A., order Part Number W10355010

In Canada, order Part Number W10355010B

*

®

affresh is a trademark of Whirlpool, U.S.A.

PERFORMANCE DATA SHEET

This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The 
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the 
permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42.

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa). 
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).

■

It is essential that operational, maintenance, and filter 
replacement requirements be carried out for the product to 
perform as advertised.

■

Use replacement filter P6RFWG2K, P6RFGEG2K, 
P6RFKG2K, Part Number ICE2.
Style 1 – When the water filter status display changes from 
“GOOD” to “ORDER,” order a new filter. When the filter 
indicator reads “REPLACE,” it is recommended that you 
replace the filter. 
Style 2 – Press FILTER to check the status of your water filter. 
If the filter indicator light is yellow and the words “ORDER 
FILTER” appear on the display screen, order a new filter. If the 
filter indicator light is red, it is recommended that you replace 
the filter. 

■

These contaminants are not necessarily in your water supply. 
While testing was performed under standard laboratory 
conditions, actual performance may vary.

■

The product is for cold water use only.

■

Do not use with water that is microbiologically unsafe or of 
unknown quality without adequate disinfection before or after 
the system.

■

Refer to the “Warranty” section for the Manufacturer’s name, 
address and telephone number.

■

Refer to the “Warranty” section for the Manufacturer’s limited 
warranty.

System tested and certified by NSF 
International against NSF/ANSI 
Standard 42 for the reduction of 
Chlorine Taste and Odor. 

Chlorine Taste/Odor

50% reduction 1.9727 mg/L 2.0 mg/L ± 10%

0.71 mg/L

0.7788 mg/L

70.2

72.81

Water Supply
Water Pressure
Water Temperature
Service Flow Rate

City or Well
30 - 120 psi (207 - 827 kPa)
33°- 100°F (0.6° - 37.8°C)
0.50 gpm (1.89 Lpm) @ 60 psi

® NSF is a registered trademark of NSF International.