Multi-Tech Systems MULTIVOIP MVP210/410/810 User Manual

Chapter 4: Configuring your VOIP 

Multi-Tech 

Systems, 

Inc. 

     

 

 

31 

The MultiVOIP software is launched from the Start button and is found in the All Programs area under the title of 
MultiVOIP x.xx (where x represents version number). The top option is “Configuration” – choose this. 

Within the software, there are several ways to arrive at the parameter that you want to use: through the left-hand 
panel, from the drop-down menu, clicking a taskbar icon (if available) or a keyboard shortcut (if available). Once 
the initial settings are entered, you may choose to configure the MultiVOIP through a Web browser instead. 

The MultiVOIP web browser interface gives access to the same commands and configuration parameters as are 
available in the MultiVOIP Windows interface except for logging functions.  When using the web browser 
interface, logging can be done by email (the SMTP option). 

Set up the Web Browser interface (Optional).  After an IP address for the MultiVOIP unit has been established, 
you can choose to configure the unit by using the MultiVOIP web browser interface.  If you want to do 
configuration work using the web browser interface, you must first set it up: 

•  Set IP address of MultiVOIP unit using the MultiVOIP Configuration program (the Windows interface). 
•  Save Setup in Windows interface. 
•  Close Windows interface. 
•  Install Java program from MultiVOIP product CD (on first use only). 
• Open 

web 

browser. 

•  Browse to IP address of MultiVOIP unit. 
•  If username and password have been established, enter them when prompted. 
•  Set browser to allow pop-ups.  The MultiVOIP Web interface makes use of pop-up windows. 
•  The configuration screens in the web browser will have the same content as their counterparts in the 

software; only the presentation differs. 

To assist with the organization of the information needed, below is a chart summarizing what is necessary. The  
–SS and –FX models do not support E&M or DID. 

D

D

IP info for VOIP unit 
• IP address 

• Gateway 

•  DNS IP (if used) 

•  802.1p Prioritization (if used) 

 

 

 

 

 

 

 

 

Interface Type 
• E&M 

• FXS/FXO* 

• DID-DPO 

Interface parameters 
(*

In FXS/FXO systems, channels used for phone, fax, 

or key system are FXS; channels used for analog 
PBX extensions or analog telco lines are FXO

). 

 

 

E&M info (only if E&M used) 

• Type (1-5) 

• 2 or 4 wires 

• Dial Tone or Wink 

 

 

 

 

 

 

Country code 

 

 

Email address for VOIP (optional) 

 

 

: Be sure to 

 after entering configuration values.