Microsoft ES4612 User Manual
Command Line Interface
4-296
4
Command Mode
Global Configuration
Command Usage
This command enables DVMRP globally for the router and enters router
configuration mode. Make any changes necessary to the global DVMRP
parameters. Then specify the interfaces that will support DVMRP multicast
routing using the ip dvmrp command, and set the metric for each interface.
configuration mode. Make any changes necessary to the global DVMRP
parameters. Then specify the interfaces that will support DVMRP multicast
routing using the ip dvmrp command, and set the metric for each interface.
Example
Related Commands
probe-interval
This command sets the interval for sending neighbor probe messages to the
multicast group address for all DVMRP routers. Use the no form to restore the
default value.
multicast group address for all DVMRP routers. Use the no form to restore the
default value.
Syntax
probe-interval seconds
no probe-interval
no probe-interval
seconds - Interval between sending neighbor probe messages.
(Range: 1-65535)
(Range: 1-65535)
Default Setting
10 seconds
Command Mode
Router Configuration
Console(config)#router dvmrp
Console(config-router)#end
Console#show router dvmrp
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway : 0.0.0.0
Metric of Default Gateway : 0
Console#
Console(config-router)#end
Console#show router dvmrp
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway : 0.0.0.0
Metric of Default Gateway : 0
Console#