Microsoft ES4612 User Manual
Multicast Routing Commands
4-297
4
Command Usage
Probe messages are sent to neighboring DVMRP routers from which this
device has received probes, and is used to verify whether or not these
neighbors are still active members of the multicast tree.
device has received probes, and is used to verify whether or not these
neighbors are still active members of the multicast tree.
Example
nbr-timeout
This command sets the interval to wait for messages from a DVMRP neighbor
before declaring it dead. Use the no form to restore the default value.
before declaring it dead. Use the no form to restore the default value.
Syntax
nbr-timeout seconds
no nbr-timeout
no nbr-timeout
seconds - Interval before declaring a neighbor dead. (Range: 1-65535)
Default Setting
35 seconds
Command Mode
Router Configuration
Command Usage
This command is used for timing out routes, and for setting the children and
leaf flags.
leaf flags.
Example
report-interval
This command specifies how often to propagate the complete set of routing tables to
other neighbor DVMRP routers. Use the no form to restore the default value.
other neighbor DVMRP routers. Use the no form to restore the default value.
Syntax
report-interval seconds
no report-interval
no report-interval
seconds - Interval between sending the complete set of routing tables.
(Range: 1-65535)
(Range: 1-65535)
Default Setting
60 seconds
Console(config-router)#probe-interval 30
Console(config-router)#
Console(config-router)#
Console(config-router)#nbr-timeout 40
Console(config-router)#
Console(config-router)#