Lucent Technologies Medical Alarms Release 3 Version 8 User Manual

6.

 The 

Status:

 field reports the progress of the migration. When the 

migration ends, 

Status:

 indicates the success or failure of the run.

7. When the migration is finished, remove the incremental tape from 

the drive and insert the original full maintenance backup 
(

) and repeat 

steps 2 through 6. 

8. To print out the customer migration log, enter:

lp /cms/migrate/r3mig.log

For help interpreting the log and its messages, U.S. customers can 
telephone the Lucent National Customer Care Center at 
1-800-242-2121; international customers should contact their 
Lucent distributors or customer representatives.

The services migration log is found in /cms/maint/r3mig/mig.log.

3

After the original server is upgraded to the same CMS version and base 
load as the new HA server, the original administration data, which was 
copied to tape in the first maintenance backup (

) is 

migrated back onto the system. After this procedure is performed, the two 
servers should share identical sets of administration data. 

.

Attempting to migrate CMS data more than once may cause catastrophic 
errors from which recovery is difficult. Before a re-migration of data can 
be performed,  CMS must be  turned off and a second setup of the CMS 
software must be performed.

3

Insert the initial maintenance backup tape back into the tape drive of the 
original server.

1. Log in as a CMS user.

The CMS main menu is displayed.

2. Select 

System Setup - CMS State 

from the CMS main menu 

and select the 

Single User Mode

 option.