INSTEON 2412N User Manual

15

®

Rev. 6/19/2012 11:45 AM

1.  Unlink all devices from SmartLinc. If you do not remove all links, the previously-linked responders 

will retry communications and cause network delays. See Removing SmartLinc as an INSTEON 
Controller for instructions.

2.  Unplug SmartLinc and wait about 10 seconds.
3.  Press and hold SmartLinc’s Set button. While holding in Set button, plug SmartLinc back in. 

4.  When beep stops, release Set button. The Status LED will turn off, then turn back on solid.

Resetting SmartLinc to its factory default settings will clear all of its internal memory. All links, room/

scene names, timers, camera URLs and check boxes will be erased and reset; DHCP will be 

enabled; the port number will be reset to 80; and SmartLinc authentication will be disabled.

1.  Navigate to the command line of the scene 

you want to control and note the On and Off 
scene strings and scene number (displayed 
below the command line).

2.  Navigate to the command line of the scene 

to which you want to add another scene’s 
control.

3.  To add another scene’s control to the current 

scene, enter either the On or Off scene string 
you noted in step 1 into its command line. 
Example command: 0261011101

Scene commands are an easy, efficient way to “copy” SmartLinc scenes.

An INSTEON scene string breaks down like this:
1.  0261: starts INSTEON scene string
2.  01: scene number of the scene to control

3.  11: corresponds to INSTEON On command
4.  01: scene number

You can change any part of the scene string to send different commands to different scenes. Use the 

INSTEON translation table on the next page to find corresponding codes.