Insignia NS-R2000 User Manual

Insignia NS-R2000 Stereo Receiver

www.insignia-products.com

2 Load two type AAA batteries into the 

compartment matching the polarity indicated.

3 Replace the cover.

Use the remote control by pointing it towards the 
receiver’s remote sensor window. Objects 
between the remote control and sensor window 
may prevent proper operation.

Use the remote control within about 23 feet 
(7 meters) of the receiver and within 30 degrees 
of perpendicular to the front of the receiver. 

1 Press the POWER button on the 

receiver to put the receiver in 
Standby mode. The STANDBY 
indicator lights up.

2 Press the POWER ON button on the remote 

control to turn the receiver on.

Remove the batteries if they are not to be used for 
a long period of time.

23’ (7m)

•

Do not expose the remote control to shock. In 
addition, do not expose the remote control to 
liquids, and do not place in an area with high 
humidity.

•

Do not place the remote control under direct 
sunlight. The heat may cause deformation of 
the remote control.

•

The remote control may not work properly if the 
remote sensor window of the receiver is under 
direct sunlight or strong lighting. In such a 
case, change the angle of the lighting or 
receiver, or operate the remote control closer to 
the remote sensor window.

The following settings are stored in memory 
before the receiver is turned off:
•

INPUT SELECTOR settings

•

Preset stations.

If the electricity fails or the AC power cord is 
unplugged for more than two weeks, your memory 
is cleared.

You can turn the receiver off by pressing the 
POWER button on the receiver while it is in 
Standby mode.

You can put the receiver in Standby mode by 
pressing the STANDBY button on the remote 
control when the receiver is on.

With the receiver in Standby mode, you can also 
turn the power on by pressing an Input Selector 
button.

OR