Hughes DW6000 User Manual
Appendix B • Installing the indoor equipment using dial-up commissioning
1033295-0001 Revision 2
79
Modem installation method
Follow the steps below and refer to the illustrations on page 80
through page 82 to install the DW6000.
through page 82 to install the DW6000.
Before beginning the installation, be sure that you have installed
the installation software correctly. See Installing the software on
page 74. In addition, confirm that TCP/IP is enabled to obtain IP
addresses automatically on your installer laptop PC. See
Appendix D – on page 121.
the installation software correctly. See Installing the software on
page 74. In addition, confirm that TCP/IP is enabled to obtain IP
addresses automatically on your installer laptop PC. See
Appendix D – on page 121.
CAUTION
Do not connect the power supply to the DW6000, or connect
the power supply to a power source, before instructed to do
so.
the power supply to a power source, before instructed to do
so.
CAUTION
• Do not block any ventilation openings. Do not install near
any heat sources such as radiators, heat registers,
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.
• Recommended ventilation space around the top and
sides of the DW6000 assembly should be approximately 6
inches. Ventilation is necessary to avoid overheating.
inches. Ventilation is necessary to avoid overheating.